When asked to read a SW modeling file the partial path is 
C\Users\Public\Public Documents\SOLIDWORKS\SOLIDWORKS 2019\tutorial

-------------------------------------------------------------------
            Mech 403 Fall 2019 Announcements
-------------------------------------------------------------------
12/19/19 Grades have been posted. ABET accreditation agency requires
         examples of good average and poor assignments. After they
         are completed papers will be returned outside room ME241.

11/30/19 Holiday hours and building construction will prevent me
         from recovering submitted design reports until Monday 
         morning. Graded reports will be placed outside ME 241
         as soon as practical. Any revised report is due the last 
         day of classes, along with the prior report.

11/13/19 I wish to review the simulation progress with each design
         group to verify the assumptions and nboundary conditions.

11/6/19  The ME office has moved for renovation. The prior dropbox
         is not accessable.  The new one is by the front door as a
         slot in the top of a file cabinet.

10/16/19 ? Where ? are you? Eight of the sixteen class members failed
         to appear in class to have the mandatory discussion with me
         about the required group design project! 

9/26/19  The paper copy of your dimensioned drawings of the solid
         part (and future assingments) at to be turned in only at
         class or at the "Dropbox" wall slot near room ME 109 in
         the Mechanical Engineering Building.  Any due date refers
         to a 5 pm drop off in the Dropbox.

         Drawings submitted where the student CLEARLY has not
         completed reading HelpFiles 2a and 2b and Weekly Notes
         1 and 3 will be labeled "Follow the Instructions", will
         not be corrected, and will still count as one of the three
         allowed submissions.

         Marked papers will be returned to class.  Unclaimed papers
         will be placed in the mech 403/203 cubby box outside room
         ME 241.

9/17/19  The national accrediation group for ME has extended the 
         required materials to be covered to include ethics and
         conflicts of interest.  Therefore, I have expanded the 
         first tutorial assignment to include also reviewing the
         ASME Conflict of Interest Policy in addition to the ASME
         Code of Ethics.

         Several sections of the conflict of interest policy apply 
         only to employees of the ASME. However, you should view 
         them as if they apply to a company that you founded, or 
         to a current employer.

         These two documents must be discussed as a part of your
         tutorials log which is due on the last day of classes.
         Copies of both documents are linked at the bottom of the
         class web page.

8/26/19  (I am being treated for stage 4 lung cancer and may have
          to miss class on short notice. In that case, proceed with
          the required SolidWorks tutorials.)